Beta 2: "Webpage using significant energy" message while trying to load homepage

[devinelston]

I have a local staging site I’d built using the prior release version of Pro - and it has been working fine. I duplicated that site, and had been testing Beta 1 on it, and it had also been performing fine.

However, after updgrading to Beta 2, I immediately started getting the “this webpage is using significant energy” message below. And this is just while visiting the homepage of that site (not even within the builder or anything).

If I downgrade to Beta 1, it starts working fine again.

To rule out there being some conflict going from Beta 1 to Beta 2, I started over and duplicated the site entirely built on the stable release version of Pro. And as soon as I install Beta 2 on there, I run into the exact same issue.

Since it’s a local staging site, what info do you need from me to dive into this?

[devinelston]

Here are some errors I see on the front end. There are a few nested loopers on most pages.

[alexander]

Hi @devinelston,

I really appreciate all the time you’re taking to try to narrow this down. I think where we need to start is just correcting those looper errors. I’ll take a look at those and let you know what I find out.

[alexander]

Update: Loopers are working again in the next patch. Also, that “Decorator” logic has been updated significantly. I didn’t see the errors you were getting, but this might clear that up as well.