Beta 2 | Global Blocks

Beta
#1

Minor GB issue: When duplicating a global block, there is no identifier which is the original and which is the copy. Previous versions would add a number I believe. Totally get that you can look at the gb ID but might throw some people off.

Major(ish) GB Issue: When switching from one GB to another you lose the apply presets, elements, etc until you refresh. Surprisingly, there is also an unsaved updates prompt on the freshly loaded page. This happens each and every time. Repro steps below:

  1. Create more than 1 global block (i.e. GB-A and GB-B)
  2. Begin editing GB-A
  3. While in the GB Builder, click hamburger and switch to GB-B
  4. Controls will be missing each and every time.

Screen Shot 2020-10-05 at 3.08.45 PM

#2

Confirmed. Thank you!

#3

Update: Duplicating properly appends a number like before. I also finally got that race condition sorted out that would cause the elements/inspector tabs to not load. Will be in the next patch.

1 Like