Pro 6.0 b4 parameter dynamic content not accessible for image source

[connexxions]

Currently it is not possible to access and add parameter dynamic content to the image source field.

For the alt text, and other fields, the Parameters section shows up in the dynamic content list

But for the image field, it is not showing up

[urchindesign]

I think you have mentioned the same thing I mentioned. Below is the response from Kory.

Pro 6 Beta 2 - Params on an image

Thanks for chiming in, @charlie. This one is a bit of an edge case to look into, but there are ways to get a Parameter value into an Image control’s input, @urchindesign. You can use either of the following methods: Click on the + in the image control and when the WordPress Media Manager pops up, click on Insert from URL in the upper-left corner of the modal. When on that tab, remove the http:// / https:// typically found in the input and place your Dynamic Content string here. Go to Dev Toolk…

[kory]

Thanks for chiming in, @urchindesign! Yes, following those steps will allow you to input DC as needed on an image control.