-
Posts
-
Hi there 😉
I’m using a video as a layer on a revolution slider. The slider will not repeat so it shows once and then stops leaving a blank screen. I’ve tried the following:
-in settings, set to loop single slide (loops only the first video layer and does not proceed to second video layer
– I tried setting up two slides with one video layer on each – again continually looped the slider/video and would not go past the first video
– I tried “stop slider after” functionality setting and again – it didn’t work.Can you take a look please and let me know where I’m going wrong?
Thanks 😉
Bek(links below)
Hey There,
Thanks for writing in!
You need to select standard or carousel slider type to make your slider loop
Please enable the Loop Single Slide on General Settings
Kindly refer to the link below for more information
http://www.themepunch.com/revslider-doc/slider-settings/
Hope this helps!
Hi Rahul 😉
Thanks – I’ve tried all that. If you look at the page you’ll see that only the first half of the slider is looping.
Thanks for your help
Bek 😉Hi Bek,
You do have a lot of slider. Would you mind pointing us which slider should we look at?
And please provide us a little more clarification on what you’re try to do.
Thanks.
Hi there 😉
It’s the slider on the page I linked to in the private message above. The one on the top right of the page. The shortcode is [rev_slider alias=”BREATHE”]. The slider is not looping properly. If you look at this slider in slider revolution you will see how it’s supposed to loop. If you look at it on the page you will see that it’s not looping properly – only looping the first half of the slider.
Thanks!
BekHi Rad 😉
Thanks so much – your sample worked perfectly when I swapped out the old slider – you’re a star!
Sorry for the slow response – it took me a while to loop back around to this
Have a sweet evening
Bek
- <script> jQuery(function($){ $("#no-reply-1157226 .bbp-template-notice, .bbp-no-topic .bbp-template-notice").removeClass('bbp-template-notice'); }); </script>
