[444mediaParticipant]

I am having a couple of issues with the slider revolution slides at: http://freedomleafinc.com/fli-agency/

1. The slides on this inner page are not being responsive despite being set to be responsive (as far as I can tell). However, where the settings are for the slides to be responsive, everything is greyed out. All of the settings for each slide directly above the slide work area, are greyed out for some reason (Style, Animation, Loop, Visibility, Behavior, Actions, Attributes, and Parallax/3D) . But I can see that the responsive setting is turned on under the Behavior setting. Please see attached screenshots (one of how it looks on mobile, and one of how the slider settings are greyed out, but responsive is on). NOTE: I TURNED ON “HIDE ON MOBILE” UNTIL THIS ISSUE IS FIXED. SO FOR NOW IF YOU GO TO THE PAGE ON MOBILE THE SLIDES ARE HIDDEN.

2. There are 3 slides total at http://freedomleafinc.com/fli-agency/ and the timing abd transition between the 3 is not consistant. For some reason, that I cannot figure out whatsoever, the transition from slide 1 to slide 2 is a fast flash (no fade); then sits at slide 2 for a very short time (much shorter than slides 1 and 3), then fades to slide 3. All of the transitions are set the same (Fade), except the only difference I can see between all 3 is in the timer bar setting below the slide 2 in the back end, is different than slides 1 & 3. SEE ATTACHED SCREENSHOT. For some reason I cannot set this to look like slides 1 & 3.

Thanks

[444mediaParticipant]

The mobile view screenshot (img_6462) was too large. Re uploaded it here

[Rue NelModerator]

Hello There,

Thanks for writing in!

To fully create a fully auto responsive sliders and slides, please check out this video tutorial:

Hope this helps.

[444mediaParticipant]

OK…I’ll take a look at this video.

What about the timing issue between the slides? I can see that I have everything set the same, except for what’s pictured in the screen shot for slide 2.

Thanks

[RadModerator]

Hi there,

Have you tried configuring each slide effect and animation? Maybe it’s set to no transition. Would you mind providing a video recording and how long should a transition should behave? Maybe I could use that for comparison.

Thanks!

[444mediaParticipant]

Hi Rad,

Finally getting back to you on your response. If you go to http://freedomleafinc.com/fli-agency/ you will see how the transition between slides 1 and 2 is a “flash”, not a fade. Then 2 to 3 fades, but doesn’t sit on slide two as long as it sits on slides 1 & 3. Then the transition from slide 3 to slide 1 is a fade….like I’d like it to fade between all three and stay on each slide for the same amount of time.

My issue is, as far as I can tell, all 3 slides are set exactly the same. I can’t figure out why there is this timing and transition difference with slide 2.

I’ll provide log in credentials in the next post and set as private just in case you need to go in and look at the slider revolution settings.

Thanks

Chris

[444mediaParticipant]

This reply has been marked as private.

[JackKeymaster]

Hi there!

I’ve checked your Slider settings and everything looks good, technically this should be working fine. I have seen this issue before though when the default values are used.

Try going to Revolution Slider > Edit the slider in question, click each slide and on the tab that says “Slide animation” where you have fade selected, set the time to custom on each one, save, clear your cache and then see if it works correctly. 🙂

Thanks!

[Author]

Posts